Solution-8 Operators Manual Page 25
MA800O3C.DOC
El
ectronics Design & Manufacturing
Master code Is a numerical code used for ARMING and DISARMING the system
as well as allowing access to all functions that are programmable
through the main codepad.
Monitoring
station
Is a secure location where a DIGITAL RECEIVER monitors
numerous alarm systems and deciphers their alarm transmission
reports so that the operator can advise the appropriate authorities to
take immediate action. Also known as central monitoring station.
Panic This is a type of alarm raised by the system user to indicate to the
MONITORING STATION that there is an emergency situation at the
premises.
Phone
Controller
Is a device used for ARMING the
Solution-8
via the Telephone
line
Sealed Refers to a zones status. If the zone is SEALED the detection devices
are not violated and the zone indicator will be extinguished. ie a reed
switch is closed or a detector is on stand by waiting for an intrusion.
Silent alarm When programming the
Solution-8
it is possible to program an
individual zone for SILENT ALARM this means that when the zone
is violated the control panel will communicate with the BASE
STATION without sounding the sirens.
Siren time A pre-programmed time which the sirens will sound for, once an
alarm condition has been generated.
Stay mode Is a condition that automatically isolates certain zones when the
system is ARMED.
Unsealed Refers to a zones status. If the zone is unsealed the detection devices
are violated and the zone indicator will be illuminated, ie a reed
switch is open or a detector has noted an intrusion.
User code A numerical code used to arm and disarm the system.
Zones A monitored input used to trigger an alarm condition.
24 hour zone A monitored input where tamper switches and emergency switches
may be connected. If at any time, whether the control panel is
ARMED or DISARMED, one of these switches is violated an
ALARM CONDITION will be generated.
To Next Page
Loading...