© Edwards Limited 2008. All rights reserved. Page 1
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
S900-01-880 Issue C
1Introduction
1.1 Scope and definitions
This manual provides installation, operation and maintenance instructions for the Edwards MSeal Booster Pumps and
Process Isolation Booster Pumps (referred to as "booster pump" or "pump" throughout the remainder of the manual).
You must use the booster pump as specified in this manual. Read this manual before you install or use the booster
pump. The booster pumps covered by this manual are listed in Section 2.3. You must only use PFPE-prepared
bareshaft booster pumps on oxygen or reactive gas service: see Section 1.3.
Read this manual before you install and use the booster pump. Important safety information is highlighted as
WARNING and CAUTION instructions; you must obey these instructions. The use of WARNINGS and CAUTIONS is defined
below.
Cautions are given where failure to observe the instruction could result in damage to the equipment, associated
equipment and process
The following IEC warning labels appear on the pump:
Warnings are given where failure to observe the instruction could result in injury or death to
people.
Warning - refer to accompanying documentation.
Warning - risk of electric shock.
Warning - trip hazard.
Warning - use protective equipment.
To Next Page
Loading...
