Edwards CDX1000 User Manual

Index
A708-01-880 Issue E
© Edwards Limited 2013. All rights reserved. Page 75
Edwards and the Edwards logo are trademarks of Edwards Limited.
A
Abnormal operation - CDX and IDX pumps 11
Accessories 10, 73
Adjust the TCV (thermostatic control-valve)
39
Air bleed - IDX1300 only 2
Allow the pump to warm up 44
ATEX system control 44
C
Change the bearings and seals
67
Change the end-cover oil filter 52
Change the gearbox oil filter 55
Change the oil and oil filters, drain the vent
filters,
and clean the oil-level sight-glasses
52
Check the coolant level 28, 50
Check the coolant level and refill if necessary
50
Check the direction of pump rotation 35, 64
Check the end-cover oil level 28
Check the end-cover oil-level 48
Check the gearbox oil-level 28, 48
Check the oil levels 28
Check the oil-levels 48
Check the shaft-seals purge gas supply 50
Clean the coolant level sight-glass 60
Clean the cooling system 58
Clean the cooling-water filter 59
Clean the heat exchanger 59
Clean the vent adaptor 65
Clean/change the air bleed filters IDX1300
only
67
Clear a hydraulic lock 65
Commission the pump 39
Commissioning procedure 39
Connect the cooling-water supply 36
Connect the electrical supply to the pump-mo-
tor 35
Connect the pump inlet and outlet 37
Connect the pump to earth (ground) 35
Connect the pump to your process system 37
Connect the pump-outlet 38
Connect the shaft-seals purge gas supply 36
Connect the temperature sensor
(CDX pumps only) 30
Connect the thermistor outputs 35
Connections 16
Coolant 17
Cooling-water supply 15
D
Description 2
Disposal 71
Drain the coolant and refill the pump with
a different coolant
51
Drain the coolant from the cooling system 59
Drain the end-cover oil and clean the end-cov-
er
sight-glasses 52
Drain the end-cover vent filter 53
Drain the gearbox oil and clean the gearbox
sight-glasses 55
Drain the gearbox vent filter 56
Drive coupling operation 3
E
Electrical data 14
F
Fault finding 67
Fill the end-cover with new oil 53
Fill the gearbox with new oil 56
Fit the new pump-motor 63
Flush the pump with cleaning solution 56
H
Hazardous area
3
Hazardous area and safe area versions
of the pump
3
I
Inspect the pipelines and connections 51
Installation 25
Introduction 1, 26, 34, 73
L
Leak test the system 39
Locate the pump 26
Locate the pump on its mounting feet 27
Locate the pump without the mounting feet 27
Lubrication data 15
M
Maintenance 47
Maintenance plan 47
Index

Edwards CDX1000 Specifications

General

Brand	Edwards
Model	CDX1000
Category	Water Pump
Language	English