D397-51-880 Issue E
Page 6 © Edwards Limited 2014. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
INSTALLATION
3 INSTALLATION
3.1 Unpack and inspect
Remove all of the packaging material and check the module. If the module is damaged, follow the Edwards return of
equipment procedures that are laid out in the back of this manual. Do not use the module if it is damaged.
Check that the package contains the items that are listed in Table 3. If any of these items are missing, notify the
supplier in writing within three days. If the module is not to be used immediately, store in suitable conditions as
described in Section 6.1.
3.2 Fitting the module
The unit is IP30 rated. Please ensure that the unit is not installed where fluids can enter into the Module.
The module can be rack mounted, panel mounted, DIN rail mounted or free-standing. Sufficient space must be
provided at the rear of the unit for the cables. If right-angled connectors are used additional space will be required.
If the unit is to be used free-standing it should be laid flat to ensure stability. The four self-adhesive rubber feet can
be used to prevent sliding. Figure 4 shows the dimensions of the module with the rubber feet attached.
Figure 4 - Dimensions of the Profibus module (mm)
Table 3 - Component checklist
Quantity Description Check()
1Module
1 Instruction Manual
1 DC Power Connector
2DIN Rail clips
2 Mounting screws
4 Rubber feet
1 CD (includes GSD file)
1 RS-232 cable for SCU connection
To Next Page
Loading...
