EasyManua.ls Logo

Edwards SCU-750

Edwards SCU-750
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Index
D397-51-880 Issue E
© Edwards Limited 2014. All rights reserved. Page 27
Edwards and the Edwards logo are trademarks of Edwards Limited.
A
Address set-up ........................................... 12
B
Bus termination ............................................9
C
Component checklist ......................................6
Configuration
............................................. 15
Configuration failure
.................................... 15
D
D.C. Power connector ....................................3
Data exchange values
................................... 16
Diagnostics description
................................. 16
Dimensions of the Profibus module (mm) .............6
DIN rail mounting ..........................................7
E
Electrical connections ....................................8
Electrical data .............................................3
F
Fault finding .............................................. 24
Fitting the module ........................................6
Front panel display
...................................... 11
I
INSTALLATION ..............................................6
Introduction
................................................1
M
MAINTENANCE ............................................ 24
Mechanical data
...........................................3
Module 01 - Pump Command .......................... 17
Module 02 - Pump State ................................ 18
Module 04 - Failure flags
............................... 19
Module 05 - Pump Speed ............................... 20
Module 06 - Motor Current ............................. 20
Module 07 - Motor Temperature
...................... 20
Module 08 - Control Unit Temperature .............. 20
Module 09 - Supervisor software version ............ 20
Module 10 - Motor Drive software version
........... 21
Module 11 - Active Magnetic Bearing software version
21
Module 12 - Profibus software version
............... 21
Module 13 - Pump Serial Number ..................... 21
Module 14 - Control Unit Serial Number ............. 21
Module 15 - Pump Run Time
........................... 21
Module 16 - Control Unit Run Time ................... 21
Module 17 - Damage Limit counter
................... 22
Module 18 - Speed Setpoint ............................ 22
Module 19 - Xh Vibration
............................... 22
Module 20 - Xb Vibration ............................... 22
Module 21 - Z Vibration ................................ 22
Module 22 - Speed Demand
............................ 23
O
Operating and storage data .............................3
OPERATION
............................................... 11
Outline description .......................................2
P
Panel mounting ............................................7
Panel mounting the Module
..............................7
Parameterisation
........................................ 15
Pin connections for 9-way ‘D’ type plug ...............5
Pin connections for 9-way ‘D’ type socket
............4
Profibus connector
........................................4
Profibus module rear connections ......................9
Profibus system information ........................... 11
R
Rack mounting .............................................7
RS232 Connector ..........................................5
S
SCU-750 control unit command interface and commu-
nications parameters .....................................9
SCU-750 control unit set-up
.............................9
SCU-800/1400/1500/1600 control unit set-up ...... 10
Serial interface cable
.....................................8
Software format
......................................... 14
Software modules ....................................... 17
SPARES AND ACCESSORIES
.............................. 26
STORAGE AND DISPOSAL
................................ 25
T
TECHNICAL DATA ..........................................3
U
Unpack and inspect .......................................6
User facilities ............................................ 14
Index

Table of Contents

Related product manuals