In case you prefer to walk with Willow, stay at a distance of 3 to 6 meter in front of your
personal robot."
Walk around your yard as per the instructions in the EEVE app, stay at least 3 meters
away from borders. Your personal robot will automatically detect the borders afterwards."
Since you control your personal robot (she follows you or you drive with her), make sure
there are never obstacles or steps higher than 2 cm between you and your personal
robot. Avoid driving over loose ground such as gravel or sand."
#
#
WARNING"
Your personal robot will always drive in a straight line towards you when you walk with her
and will not stop for obstacles. Be sure there are no obstacles, water, loose ground, pits
or steps higher than 2 cm between you and Willow."
Once you completed a tour around your yard, walk or drive back to your charging station."
It is recommended that you walk or drive towards the docking station, in front of the
docking station, in a straight line for at least 3 meter in front of the station. Walk or drive in
a straight line towards the station."
Your personal robot will automatically dock on the station when you tap finish in the app.
Once your personal robot starts to dock you can move away from the station."
Once your personal robot is docked, she will automatically create her map, this may take
up to several hours or days, depending on the complexity of your yard."
In case your personal robot encounters an error during the process, your personal robot
will stop and show ‘sad eyes’. You need to restart the procedure when this happens. You
can restart your personal robot by placing your personal robot on the docking station."
Once the map is created you have to define the work area of your personal robot."
The perimeter can be defined in 3 ways:"
9.5.1 grass border"
By default, your personal robot will search automatically for the grass border. The grass
border will be the final perimeter for your personal robot unless you install a gateway to
go to another zone. Your personal robot will automatically adjust her map when the grass
border changes."
In case you have visual borders (non-grass) around your work area you can use the
default perimeter. The default perimeter based on the grass border is always active,
automatically.#
To Next Page
Loading...