9.4 Setup your Personal Robot - the onboarding procedure."
Open the app and follow the procedure in the app:"
• Enter your email-address (= your unique ID for your personal robot)."
• Verify your email-address by activation the verification email."
• Enter your WiFi network information."
9.4.1 auto-docking test"
During the onboarding process you need to run the auto-docking test to assure that your
docking station is properly installed. Place your personal robot on the docking station and
start the auto-docking test.#
#
During the auto-docking test procedure your personal robot will drive 1,5 meter in front of
the charging station, rotate 180° and dock. Your personal robot can do this up to 3 times
if needed during an auto-docking test."
9.4.2 StarLight"
StarLight offers you the tools to configure zones for your robot. You can configure zones
such as grass, stone floor, narrow passages, digital perimeter, stepping stones, water
zones, safe border mowing zones…"
9.4.3 Map"
• Make a map to scan your garden environment."
9.5 Setup the work area for your Personal Robot"
Your personal robot uses a digital perimeter to define her working area."
Your personal robot uses a map to navigate in your yard. On that map your personal robot
uses a digital perimeter to understand where the perimeter of her work area is."
When she arrives at your home your personal robot doesn’t has a map."
To create a map you need to show your personal robot her working area. You will do that
during the last step of the onboarding process by following the procedure in the app."
After installing the docking station, and at the end of the onboarding procedure, you will
be able to show your personal robot the way around your yard."
You can walk around your yard while your personal robot follows you or you can use the
remote control joystick to drive around with your robot if you have a proper WiFi or 4G
connection in your yard."
To Next Page
Loading...