1. Introduction
Thank you for your purchase. The instructions provided in this manual are essential to harnessing
the full potential of your EEVE personal robot, and to ensuring your safety during its operation. We
strongly recommend adhering to these guidelines to prevent any risk of injury and to maximize the
performance and satisfaction derived from your new personal robot.#
"
IMPORTANT#
READ CAREFULLY BEFORE USE!
KEEP FOR FUTURE REFERENCE "
Because one of the personal robot’s task is to mow it can activate its high-speed cutting
tool, designed for operation independent from the active control or supervision of an
operator, special safety precautions must be observed to reduce the risk of personal
injury. "
Read this instruction manual thoroughly before setting up your personal robot and
periodically thereafter. Follow all safety precautions. Careless or improper use of the
personal robot can cause serious or fatal injury. "
Discuss setup and operation of your personal robot with your authorized EEVE Partner.
EEVE recommends having an authorized EEVE Partner set up your personal robot. "
Do not lend or rent your personal robot without this instruction manual. Allow only
persons who fully understand the information in this manual to set up, operate or maintain
the personal robot. The operator must be familiar with the personal robot's controls
before starting work. The operator is responsible for accidents or hazards occurring to
other people or their property. "
For further information, or if you do not understand any of the instructions in this manual,
contact your authorized EEVE Partner."
This manual contains safety information that requires your special attention. Such
information is introduced with the following symbols and signal words:#
"
#
DANGER#
#
Indicates a hazardous situation that, if not avoided, will result in death or serious injury. "
#
WARNING#
#
Indicates a hazardous situation that, if not avoided, could result in death or serious injury. "
NOTICE#
Indicates a risk of property damage, including damage to the machine or its individual
components. "
To Next Page
Loading...