EEVE Willow - Personal Robot

document version: 2.1.1 - English - 20.05.2023! Instruction manual
18.2 Personal robot"
Always activate the disabling device before carrying out any inspection, cleaning or
maintenance. "
Lift detection.
your personal robot has been lifted.
Place the personal robot on the
ground."
Open the message and tap
‘continue’ in the message.#
OR"
Manually place your personal robot
on the Docking station.
Rollover.
A rollover has been detected.
Place the personal robot on the
ground."
Open the message and tap
‘continue’ in the message.#
OR"
Manually place your personal robot
on the Docking station.
Rain detected.
Rain has been detected.
No action needed; your personal
robot will return to the charging
station if not yet docked.
Heavy rain detected.
Heavy rain has been detected.
No action needed, your personal
robot will stop the operation and
wait until the rain stops to return
back to the docking station.
Alternatively you can manually
place your robot on the charging
station.
Message
Possible cause
Remedy
Condition
Possible cause
Remedy
The personal robot
doesn’t connect to the
WiFi during the initial
setup.
Wrong WiFi network name (SSID) or
wrong password.
Start over, enter the correct WiFi
settings. Be aware that WiFi
settings are case sensitive.
The personal robot drives
into my flower bed or gets
stuck in the border.
your personal robot doesn’t
recognize the flower bed or grass
border.
Clean weeds and grass out of the
border."
Contact support@eeve.com to
capture images from your flowerbed
and have Willow trained to
recognize the flowerbed.
The personal robot drives
over obstacles.
your personal robot doesn’t
recognize the obstacle.
Contact support@eeve.com to
capture images from the obstacle
and have Willow trained to
recognize the flowerbed.
EEVE BV, Belgium! Original Instruction! Page of 45 53