9.5.2 fixed digital perimeter"
You can set a fixed digital perimeter, via the map, to become the final perimeter for your
personal robot. When you set the digital perimeter as the final perimeter your personal
robot will not cross that digital perimeter."
Set the fixed digital perimeter during the onboarding process. Or set the digital perimeter
afterwards by using the StarLight tool, either manually or by the StarLight Configurator.#
#
#
WARNING#
When using a fixed digital perimeter please take into account that the fixed digital
perimeter has an accuracy of 300 cm. Your personal robot will only go over the fixed
digital perimeter with maximum 300 cm, nevertheless, to reduce the risk of your personal
robot mowing out of the fixed digital perimeter we advise you strongly to take 450 cm
safety margin into account when using the fixed digital perimeter function."
9.5.3. StarLight Beacon perimeter"
In case you need to achieve centimeters
precision perimeter to determine your work area
you can place StarLight Beacons at every 2
meter on the location where you want to achieve
a centimeter precision perimeter. "
You can buy StarLight Beacons via our
accessoires shop at eeve.com or by contacting
our support team via support@eeve.com."
10. Charge the personal robot
Read and follow the personal robot and docking station safety precautions and
instructions in this manual. Be alert for signs that the integrated battery may be damaged.
To reduce the risk of personal injury from short circuit, fire and explosion, never use or
charge a personal robot if the hood or housing is cracked, deformed or excessively hot, if
battery fluid is leaking from the battery compartment, or if the battery is otherwise
damaged."
#
WARNING"
To reduce the risk of electric shock, charge the personal robot only in the docking
To Next Page
Loading...