Efka dc1550 - Page 10

Instruction Manual
- 10 -
Functions
Parameter
Call-up of the Fast Installation Routine SIR
(Sir)
500
Setting on the V810 control panel:
 Input code number 3112!
 Press the E key

the lowest parameter 2.0.0. of this level appears
 select 500

Parameter 5.0.0. displayed
 Press the E key

the character [o] appears and flashes
 Press the >> key

Parameter 2.9.0. appears (functional sequence "thread trimming
operations")
 Press the E key

Parameter value 05 appears
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 1.6.1. appears (Direction of motor rotation)
 Press the E key

Parameter value 1 appears
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 2.7.2. appears (transmission ratio)
 Press the E key

Parameter value 100 appears
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 2.7.0. appears (type of position sensor)
 Press the E key

Parameter value 0 appears
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 4.5.1. appears (position 1 leading edge, position 1 trailing edge
is automatically set at 60°)
 Press the E key

Parameter value appears
 Press the +/- key

The parameter value can be changed
 or turn handwheel

Set position for at least 1 rotation.
 Press the E key

Parameter 4.5.3. appears (position 2 leading edge, position 2 trailing edge
is automatically set at 60°)
 Press the E key

Parameter value appears
 Press the +/- key

The parameter value can be changed
 or turn handwheel

Set position for at least 1 rotation.
 Upon pressing the E key once more the program returns to parameter 290!
 Press the P key twice

The system exits the SIR routine
Setting on the V820/V850 control panel:
 Input code number 3112!
 Press the E key

the lowest parameter 2.0.0. of this level appears
 select 500

Parameter 5.0.0. displayed
 Press the E key

the character [o] appears and flashes
 Press the >> key

Parameter 290 FAm 05 appears (functional sequence "thread trimming
operations")
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 161 drE 1 appears (Direction of motor rotation)
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 272 trr 100 appears (transmission ratio)
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 270 PGm 0 appears (type of position sensor)
 Press the +/- key

The parameter value can be changed
 Press the E key

Parameter 451 appears (position 1 leading edge, position 1 trailing edge is
automatically set at 60°)
 Press the +/- key

The parameter value can be changed.
 or turn handwheel

Set position for at least 1 rotation.
 Press the E key

Parameter 453 appears (position 2 leading edge, position 2 trailing edge is
automatically set at 60°)
 Press the +/- key

The parameter value can be changed
 or turn handwheel

Set position for at least 1 rotation.
 Upon pressing the E key once more the program returns to parameter 290!
 Press the P key twice

The system exits the SIR routine