Efka dc1550 - Set and Reset Operating Hours Counter

- PF321A6012
- 21 -
Display example of operating hours or hours since the last service and operating hours counter reset.
Display on the control:
 Select parameter 177.
 Press the E key

Sr7
 Press the >> key

h t
(hours /thousands letter symbol)
 Press the E key

000
hours /thousands display)
 Press the E key

h h
(hours / hundreds letter symbol)
 Press the E key

000
(hours / hundreds display)
 Press the E key

Min
(minutes letter symbol)
 Press the E key

00
(minutes display)
 Press the E key

SEc
(seconds letter symbol)
 Press the E key

00
(seconds display)
 Press the E key

MS
(milliseconds letter symbol)
 Press the E key

000
(milliseconds display)
 Press the E key

rES
see chapter “Set and Reset Operating Hours Counter “
 Press the E key

The process will be repeated from the hours display.
 Press the P key twice

e. g. 400
(sewing process can be started)
Display on the V810 control panel:
 Select parameter 177.
 Press the E key

Sr7 [°]
 Press the >> key

hoUr
(hours letter symbol)
 Press the E key

000000
(hours display)
 Press the E key

Min
(minutes letter symbol)
 Press the E key

00
(minutes display)
 Press the E key

SEc
(seconds letter symbol)
 Press the E key

00
(seconds display)
 Press the E key

MSEc
(milliseconds letter symbol)
 Press the E key

000
(milliseconds display)
 Press the E key

rES F2
see chapter “Set and Reset Operating Hours Counter “
 Press the E key

The process will be repeated from the hours display.
 Press the P key twice

e. g. PF321A
(sewing process can be started)
Display on the V820/V850 control panel:
 Select parameter 177.
 Press the E key

F-177
Sr7 [°]
 Press the >> key

hoUr
000000
(hours display)
 Press the E key

Min
00
(minutes display)
 Press the E key

Sec
00
(seconds display)
 Press the E key

MSEc
000
(milliseconds display)
 Press the E key

rES
F2
see chapter “Set and Reset Operating
Hours Counter “
 Press the P key twice

e. g. 3500
PF321A
(sewing process can be started)
6.16.1 Set and Reset Operating Hours Counter
The number of hours has been reached (service necessary):
 Press the >> key or F2 once

The operating hours counter is set to "0" and restarted.
The number of hours has not yet been reached:
 Press the >> or F2 key 3 times

The operating hours counter is set also to "0" and
restarted.
A value in parameter 177 has been changed:
 After displaying rES ..., when the E key is pressed again, SEt will then be displayed.
 If the changed value is to be saved, press the >> or F2 key 3 times.