Instruction Manual
30 High lift for walking foot: Upon pressing the key, high lift for walking foot is enabled if the sewing
foot is On.
31 Function "speed limitation bit0": Upon pressing the key, the speed n11 will be enabled. Upon
simultaneously pressing the keys “bit0” and “bit1”, speed n9 will be enabled.
32 Function "speed limitation bit1": Upon pressing the key, speed n10 will be enabled. Upon
simultaneously pressing the keys “bit0” and “bit1”, speed n9 will be enabled.
33 Speed n9: Below this speed, operation can be pedal controlled.
34 Automatic speed n9: The speed can be suspended by pressing the pedal to position 0.
35 Automatic speed n9: The speed can be interrupted by pressing the pedal to position -2.
36 Automatic speed n9: Not influenced by the pedal.
37 Speed n12 with break contact: Below this speed, operation can be pedal controlled.
38 Automatic speed n12 with break contact: Not influenced by the pedal.
39 Switch to the next pattern in TEACH IN: Upon pressing the key, the program switches to the next
pattern.
40 Switch back to the previous pattern TEACH IN: Upon pressing the key, the program switches to the
previous pattern.
41 No function
42 No function
43 No function
44 Function like pressing the pedal to pos. –2: Upon pressing the key, the seam end is initiated. If the
functions “end backtack“ and “trimming operation” are activated, they will be completed. The drive stops in
position 2.
48 Signal A1 is issued: Upon pressing the key, signal A1 is issued immediately.
49 Signal A1 switchable as flip-flop:Upon pressing the key, signal A1 is activated and deactivated when
pressing the key again.
50 No function
51 Signal A2 is issued: Upon pressing the key, signal A2 is issued immediately.
52 Signal A2 switchable as flip-flop:Upon pressing the key, signal A2 is activated and deactivated when
pressing the key again.
53 No function
54 Function like pressing the pedal to step 12: If start backtack or softstart is enabled, it will be performed.
55 Reversal of the direction of rotation
56 No function
57 Sensor for bobbin thread monitoring (see F-835)
66 Thread trimming is suppressed
67 Thread trimming and backtacking are suppressed
68 Interruption of seam in TEACH IN and switch to next seam.
69 Interruption of seam in TEACH IN and switch to preceding seam.
70 No function
71 No function
72 Switching of basic position (see F-329)
77 Switch stitch length: flip-flop function
84 Move toward reference point
85 Reference point reached
90 Sensor for zig-zag position (see F-040)
91 No function
92 No function
93 Threading in
94 Multifunction keys (programmable)
95 Multiple backtack
96 Backtack disabling of all automatic backtacking
97 Single stitch backwards
98 Edge trimmer On/Off
To Next Page
Loading...