EN‐18
MA510a_EN
Instruction’sManual
Installation
The electric safety is insured only when the same are correctly
connected to an efficient net linked to the earth in conformity with
the actual safety requirements. It is necessary to verify this
fundamental safety requisite and, in case of doubt, to require an
accurate control of the plant from part of qualified per
sonnel. The
manufacturercannotbeconsideredresponsibleforpossibledamages
caused from the lack of efficient connection to earth of the
installation. Operation without a protective earth connection is
forbidden.
Before connect the equipment ascertain that the required voltage
(showedontherearpanel)correspondstotheavailablemains.
In case of incompatibility between the available wall so
cket and the
feeding cable of the equipment, replace only with legally approved
connectors and accessory items. The use of adapters, multiple
connections or cable extensions is not advised. Should their use
become necessary it is mandatory to use only simple or multipl
e
adapterconformingtotheactualsafetyrequirements.
Don'tlettheapparatusexposedtoatmosphericagents.Theunitmust
be protected from seepage of liquids. Don't obstruct openings or
cracksofventilationorheathsink
Don't leave the equipment uselessly inserted. Switch off the
equipmentwhennotinuse.
Theuseoftheunitisnotsuitedinex
plosiverooms.
Equipment must be destined only to the use for that have been
expressly designed. Any other use is to be considered improper and
dangerous. The manufacturer can not be considered responsible for
possibledamagesduetoimproper,wrongan
dunreasonableuses.
It is dangerous to modify or try modifying the characteristic of the
equipment.
Before effect any operation of cleaning or maintenance, disconnect
the apparatus from the electric net, either unplugging it from the
mainsorswitchingoffthemainsswitchoftheplant.
Incasefailureand/orbado
perationofequipmentswitchoffit.Forthe
possible reparation address only to an authorized service centre and
ask for the use of original spare parts. The lack to follow the above
requirements could risk the safety of the equipment and can be
dangerousfo
rtheuser.
To Next Page
Loading...
Need help?
General
