Eighteeth Ultra X - Setting up the Ultra X; Installing the sleeve; Installing the tip; Tip Removal

4 Setting up the Ultra X
Page 8 / 28
Setting up the Ultra X
Installing the sleeve
Always use a silicone sleeve.
Installing the tip
Make sure the thread on the tip is
aligning to the stud of the handpiece.
Plug them together and turn it carefully
NOTE
 Only the original tip can be used.
 The Activator tips are not sterile
when deliver and must be
autoclaved before being used for
the first time
 Clean and disinfect the Activator
tips before every use
Tighten the tip clockwise with provided
wrench until the tip secure.
When you set the tip on the device, the
tip can be set within a range of 10°,
therefore, do not tighten the tip in
excess.
Warning
 Inspect the tip before inserting. Do
not use the damaged tip.
 Make sure the device is stopped
when inserting and removing tips.
 Pull the tip gently to make sure that
the tip is secure in handpiece
properly, otherwise it may pop out
and hurt the patient.
Tip Removal
Loosen the tip counterclockwise with
provided wrench until the tip shedding.
Warning
 Estimated case number of uses per
tip: 20, taking 2 root canals per case
as a reference.
Be careful when inserting and removing
tips to avoid injury to fingers.