MAINTENANCE
16 SM-DK50 DS-EN-20_02-2016
5. MAINTENANCE
REPAIRS AND SERVICE
Warranty and extended warranty repairs are to be completed by the
manufacturer or a service provider authorized by the manufacturer.
The manufacturer reserves the right to modify the equipment in any
way that will not alter the function or the operation of the equipment.
Only a qualified technician or the Customer Service Department of the
manufacturer may perform repairs that go beyond routine maintenance.
Use only spare parts and accessories approved by the manufacturer.
Prior to any maintenance or repairs, switch off the compressor and
disconnect it from the mains (pull out the main power plug).
Cover removal
- Unscrew the 6 screws from the rear cover
- Disconnect the grounding wire
- Remove the rear cover
- Disconnect the wiring connector for the display and pull the wiring out from
the opening in the frame
- Unscrew the 4 screws from the rear of the main cover and 2 screws from
the rear part of the rail
- Disconnect the grounding wire
- Remove the main cover
- Reassemble using the opposite order
MAINTENANCE SCHEDULE
Maintenance Page
Time interval (Hour)
4000 8000
Safety valve check 17 1 x per year
Test the tightness of joints and
inspect the equipment
17 after two years
Replace service kit A (filters) 18 x x
Replace service kit B 19-21 X*
*) – The suction filter replacement interval must be shortened accordingly if
used in a dusty or dirty environment!
To Next Page
Loading...
