MAINTENANCE
28 SM-DK50 DS-EN-20_02-2016
The pressure sensor must be checked when any service work is completed
on the unit; if water is present, blow out with compressed air and dry it out.
The long-term presence of water in the sensor can destroy the sensor. After
regular service work is completed, the service hour counter must be zeroed
out using the procedure described in the “Service Display” chapter.
Stabilizing the compressor before shipping
Before shipping, the compressor must
be stabilized to prevent movement.
Prior to fixation, it is necessary to
disassemble the plastic cover. The air
pump must be fixed to the base using
the four original M6 screws (see
picture). Assemble the plastic cover.
SHUT-DOWN
If the compressor is not going to be used for a long period of time,
disconnected it from the main power supply and release the pressure in the
air tank.
EQUIPMENT DISPOSAL
Disconnect the equipment from the main power supply.
Release the pressure in the air tank.
Dispose of the equipment according to local regulations.
Parts used in this product have no negative impact on the environment
when disposed of properly.
BATTERY DISPOSAL
No battery may be disposed with common household waste. Dispose of
non-functional batteries at suitable collection sites.
To Next Page
Loading...
