ELBO CONTROLLI Nikken E346+ - Certification

2. CERTIFICATION ELBO CONTROLLI srl
Preset E346+/V+
4
2. CERTIFICATION
The manufacturer, ELBO CONTROLLI Srl., under its own responsibility,
DECLARES THAT:
the pre-registration and tool management tools models E346+ ed E346V+ conforms to the following safety
standards where enforceable:
• 2006/42/CE Machinery Directive (MD)
to the harmonized standards EN ISO 12100:2010
• 2014/30/UE Electromagnetic Compatibility Directive (EMC)
to the harmonized standards EN61326-1:2013, EN55011:2009+A1:2010 ISM (group 1, class A),
EN61000-3-2:2014, EN61000-3-3:2013, EN61000-4-2:2009, EN61000-4-
3:2006+A1:2008+A2:2010, EN61000-4-4:2012, EN61000-4-5:2006, EN61000-4-6:2009,
EN61000-4-11:2004
• 2014/35/UE Low Voltage Directive (LVD)
to the harmonized standards EN60950-1:2006+A2: 2013, EN60204-1:2006+A1:2009, EN61010-
1:2010
• 2011/65/UE Restriction of Hazardous Substances (RoHS II)
• 2012/19/UE Waste Electrical and Electronic Equipment (WAEE)
as shown in the technical file and the enclosed test reports, stored at our headquarters.
MEDA, ____________ Massimiliano Tasca
General Manager
Information relating to this presetter is listed on the identification plate stamped on the left-hand side of
the machine as shown above. .