ELBO CONTROLLI Nikken E346+ - Warnings; Introduction; Purpose; Typographical Convention

3. WARNINGS ELBO CONTROLLI srl
Preset E346+/V+
5
3. WARNINGS
3.1 INTRODUCTION
The following operation and maintenance manual of the E346+/V+ should be considered an integral part
of the apparatus and it should therefore be kept with care for future reference.
All the procedures and information contained in the manual cannot be a substitute for the end user’s
adequate tool presetting experience, but they provide the necessary information for the correct and proper
use of the PresetterE346+/V+.
Unauthorized equipment handling, non-compliance of instructions or improper or incorrect use may lead
to unforeseen results for which ELBO CONTROLLI Srl. declines all civil or criminal liability.
ELBO CONTROLLI Srl. reserves the right to modify at any time the tool presetter and the operator’s manual
without prior notification on account of the continuous technical updating of the product in pursuit of the
Company strategy aimed at perfecting presetter technology of tool measurement and presetting and of
customer satisfaction.
All suggestions for improvements of the apparatus or manual are welcome either by fax or email to our
head office.
3.2 PURPOSE
The aim of the present manual is to allow the operator of the presetter E346+/V+ to become acquainted
with the machine operating directions, routine and non-routine maintenance, the proper operating
procedures, and to show all the required necessary actions from the Presetter’s introduction until disposal
Implement only the allowed use and the configuration reported, approved by ELBO CONTROLLI Srl.; any
other use or configuration is not recommended, as it may compromise the tool’s proper functioning and/or
its safety.
The manual does not substitute or replace the experience and the technical expertise of the personnel
involved in the use of the Preset machine and is to be considered as a guide at all times.
This manual must be read following the chapters in their logical order, because the repeated
information is explained in full the first time it appears, thereafter it is only mentioned because it
constitutes knowledge already acquired.
3.3 TYPOGRAPHICAL CONVENTION
This manual is sub-divided into chapters, which contain homogeneous information; each chapter is
identified by a title in the following typographical character:
X. FIRST CHAPTER
Each chapter is sub-divided into individual paragraphs into following typographical format:
X.X FIRST PARAGRAPH
 Notes or instructions of particular interest are indicated by the following typographical format:
 Notes or Instructions of particular interest.