5. PREPARATION AND INSTALLATION ELBO CONTROLLI srl
Preset E346+/V+
9
5.2 SAFETY NORMS
The personnel destined to use the Presetter E346+/V+ are not required to use any particular protection;
however, they must be informed of the following potential dangers:
• In particular during the vertical axis measurement positions, the vision system of the support
structure can be a hazardous obstacle at head height if the machine is used without the neccessary
care and attention.
• We recommend the careful handling of tools due to their sharp and potentially dangerous nature.
The person responsible for employee safety should train the people required to use the tool presetter by
insisting on the reading of this manual. (per l’Italia vedi D.Lgs. 81/2008 come modificato da D.Lgs. n.
106 del 3 agosto 2009).
5.3 SUGGESTED USE OF THE MACHINE
The E346+/V+ Tool Presetter is an instrument to preset and measure the tools surveying their dimensions
along X-Z-axes, in accordance with the axes definition of the machine using the above-mentioned tools.
The measurable tools are to be compatible with the presetter spindle; any attempt to adapt the tool presetter
spindle taper without using the appropriate adaptors supplied by ELBO CONTROLLI Srl. is to be considered
improper use.
The maximum weight of the tool to be measured should be no more than 30Kg.
Any other use is to be considered improper and potentially compromising to the operator’s safety.
The E346+/V+ Presetter is to be handled by a single person in conditions of tested and controlled
efficiency, in respect of all procedures described in this manual.
5.4 PACKING, TRANSPORT AND STORAGE
The instrument must be handled inside its proper cardboard box, which prevents it from normal mechanical
stresses.
Stated on the outside of the packaging are the shipping instructions, particularly the specified total weight,
transport position and using symbols, vulnerability to atmospheric agents and the need to handle with care.
Keep the original packing and use it for further transportation of the instrument.
Tool Presetter transportation is to be carried out by qualified carriers able to grant the correct handling of
the transported goods, observing the following precautions:
• lift only with trolleys or pallet jacks;
• do not bump, throw, drop, roll or drag the case;
• do not overcharge the packing by piling more than three cases;
• avoid exposure to atmospheric agents;
• maintain the prescribed transportation position.
The storage environment must fall within the following environmental conditions:
• safe from atmospheric agents;
• temperature between -10 and 50 °C;
• relative humidity between 20% e 95% without condensation.
To Next Page
Loading...