DmPackagingGroup
s.r.l
StradadelCascinotto156,
10156,Torino(TO)-Italy
Tel:011.99.10.455
e-mail:
info@dmpackagingroup.com
In this environment, you can enable and configure the operation of the following three
optional devices:
● Printer
● Labeler
● Nebulizer
●
They Can be configured by setting the following parameters:
● "Enable": selecting NO the related device will never be activated. Selecting YES
the related device will be active during the execution of a work cycle
● “Offset printing ": blade position at the corresponding accessory is activated. The
set position is a absolute value referred to zero axis blades(blades in contact).
Activation is carried out once for each package made by the machine.
● "Activation time": Time in milliseconds for which the corresponding device is
activated when the position set in the previous parameter is reached
The left side of the screen contains buttons to access other areas of the software. From
top to bottom these buttons allow access to:
● main menù
● work environment
● chain management
● cut / weld management
● manual
● printer management (current environment)
20
To Next Page
Loading...