elco TOP7 - Extended Axis Data

DmPackagingGroup
s.r.l
StradadelCascinotto156,
10156,Torino(TO)-Italy
Tel:011.99.10.455
e-mail:
info@dmpackagingroup.com
USER MANUAL TOP7
SW: EFPLCAC0
Date:
15/02/2016
● Entering the "Data axes extended" by pressing the button "Parameters." The page
that appears , is the same that is accessible by pressing the button "EXTENDED
DATA" of the parameters manufacturer pages .
● Access to the test environment by pressing the button "Test I". See : environment
chapter TEST I / O.
● Start the application by pressing the button "Start PLC".
● TOP7 reset by pressing the button "Restore to Factory Settings" and click on OK in
the next query. WARNING: If you perform this procedure the TOP7 will loose
all data and wil not be able to control the machine. To restore the TOP7,
download the application software with the procedure described in Section
1.2 and load the .cfg file that contains the application parameters or set all the
parameters manually.
●
3.15 – EXTENDED AXIS DATA
37