CHAPTER 4 –WARNING MESSAGES
The software monitors for emergency conditions . Depending on the emergency , a
related message will be displayed ( listed below):
● "Emergency push button": the emergency button is pressed (digital input number
4 is false logic state). In this case, release the emergency button or, if already
released , verify its connection to TOP7.
● "Carter opened": safety carter is open (digital input number 5 is false logic state).
In this case, close the cover or, if already closed, verify its connection to TOP7. In
this situation , axis movements are still permitted ( in manual environment ).
● "Axis chain not present": the drive axis control for the chain is off or disconnected
and therefore not detected by TOP7.
● "Axis blades not present": the drive axis control for the blades is turned off or
disconnected and therefore not detected by TOP7.
● "Axis roller not present": the drive roller axis control is turned off or disconnected
and therefore not detected by TOP7.
● "Axis chain alarm": the drive axis control for the chain is in alarm state. For
details of the alarm refer to the documentation of the drive.
● "Axis blades alarm": the drive axis control for the blades is in alarm. For details of
the alarm refer to the documentation of the drive.
● "Axis roller alarm": the drive axis control for the rollers is in alarm. For details of
the alarm refer to the documentation of the drive.
● "Emergency FTC chain": the adjustable control in the parameter "Number of
emergency periods FTC"has been activated. The number of cycles set in parameter
were executed ,without transition of the chain 's FTC.
● "Emergency FTC blades": the adjustable control in the parameter "Number of
emergency periods FTC"has been activated. The number of cycles set in parameter
were executed ,without transition of the chain 's FTC.
45
To Next Page
Loading...