Electro-Voice ELX200-12 - Page 10

10 en | Tripod and floor monitor operation ELX200 Passive Loudspeakers
2019-04 | 02 | F.01U.326.890
Installation manual
Electro-Voice
Mounting a loudspeaker on a pole
!
Caution!
We recommend that two or more persons lift and place heavier loudspeakers. Single person
lift and placement of heavier loudspeakers could cause injury.
To mount a loudspeaker on a pole, do the following:
1. Place the subwoofer on a level and stable surface.
2. Insert the M20 threaded pole into the combo pole cup on the top of the subwoofer.
3. Turn the M20 threaded pole clockwise to secure the pole to the subwoofer.
4. Using two hands lift the loudspeaker.
5. Set the pole cup located on the bottom of the loudspeaker onto the pole.
6. Tighten the thumb screw to secure the loudspeaker to the pole.
The thumb screw is only available on the 12" and 15" full-range loudspeaker models. The
10" full-range loudspeaker does not have a thumb screw.