Electro-Voice ELX200-12 - Installing the eyebolts

ELX200 Passive Loudspeakers Suspension | en 13
Electro-Voice
Installation manual
2019-04 | 02 | F.01U.326.890
Installing the eyebolts
To install the eyebolts, do the following:
1. Remove the three fly point covers from the suspension points.
2. Install M10 eyebolts and washers into the suspension points.
!
Warning!
Eyebolts must be fully seated and oriented in the plane of pull. Always use washers under the
eyebolt to distribute the load on the enclosure.
B
A
Figure4.2: Eyebolt shown with washers (A) and without washers (B)
Figure4.3: Eyebolts shown orientated in the plane of pull (left correct, right incorrect)