Electro-Voice ZLX-12P-G2 - System Status

ZLX-G2 Full-range loudspeaker Amplifier DSP | en 21
Bosch Security Systems, LLC
User manual
2023-10 | 01 |
3. Input selection soft keys - Press the soft key to select the input and access the DSP
control menu for the channel. Press the softkey a second time to deselect the channel
and return to the main DSP.
4. INPUT 1 - Balanced INPUT for the connection of signal sources like mixing consoles,
instruments, or microphones. Connections can be established using ¼-inch TRS or XLR
connectors. The XLR connector is switchable for 24V phantom power.
5. INPUT 2 - Balanced INPUT for the connection of signal sources like mixing consoles,
instruments, or microphones. Connections can be established using ¼-inch TRS or XLR
connectors
6. MIX OUT - XLR output sends either the mix of all input signals or the stereo L or stereo
R signal to another loudspeaker or subwoofer.
7. Hi-Z - High impedance connection to connect an instrument or high impedance
microphone via a ¼-inch TS cable. Shared with INPUT2.
8. MAINS IN – AC connection is established via an IEC-connector.
9. POWER - Switch for power ON or OFF of the loudspeaker. The LCD screen lights up
when the power is turned ON, after approximately three seconds.
7.2 System status
Normal
1
11 10 12
9
2
3
4
5
6
7
8
1. Indicates the master gain of the system in dB. The range is from -80dB to +10dB, in
1dB increments.
2. IN1 - VU meter displays the signal level of INPUT1 into the amplifier INPUT1
connector. The display of PHANTOM indicates 24V phantom power is switched on.
3. Input level control for IN1.
4. IN2 - VU meter displays the signal level of INPUT2 into the amplifier INPUT2
connector.
5. Input level control for IN2.
6. BT - VU meter displays the signal level of INPUTBT into the amplifier from Bluetooth®
streaming connection.
7. Input level control for BT.
8. M - VU meter displays the signal level of the MAIN output.