Electro-Voice ZLX-12P-G2 - Regulatory Information; FCC Information

ZLX-G2 Full-range loudspeaker Appendices | en 51
Bosch Security Systems, LLC
User manual
2023-10 | 01 |
BASS 0dB (Default)
-12dB - +12dB
BAL (stereo operation only) C (Default)
10 L - 10 R
BLUETOOTH BACK
BLUETOOTH ON (Default)
OFF
ID (4-digit unique device number)
CONTROL PAIR
AUDIO PAIR
LINK SPEAKERS
BACK
EXIT
Table12.9: INPUT BT DSP control menu MIXER mode
12.5 Regulatory information
12.5.1 FCC information
IMPORTANT: Do not modify this unit! Changes or modifications not expressly approved by
the manufacturer could void the user’s authority, granted by the FCC, to operate the
equipment.
i
Notice!
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception or receive
audible interference from radio, television or communications equipment, which can be
determined by turning the equipment off and on. The user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV/communications equipment technician.
The device has been granted by FCC and IC, the FCC ID: ESV-ZLXG2 and IC: 1249A-ZLXG2.
Please take attention that changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This equipment should be installed and operated with a minimum distance of 20cm
between the radiator and your body.