ATS-5X User Manual Page 28 of 44
The DTMF digit capturing feature will display the last 16 valid digits received. Any of these digits mat be selected to
display the level, frequency and time statistics for that digit. The measurements for all 16 digits may be saved to a USB
drive.
Figure 37 – Dialer Screen
2.7.4.2 Setup
There are no restrictions on the line interface settings for this measurement.
The following transmit modes are permitted for this measurement:
Off
1004 Hz
Single Tone
23-Tone
P/AR
The Setup screen shows an additional adjustment for the transmit level of DTMF digits, DTMF TxLevel (dBm) (see Figure
38). This adjustment specifies the combined DTMF transmit level of both tones of the DTMF digit.
Figure 38 – Dialer Setup
2.7.4.3 Measurement and Controls
The following measurements related to captured DTMF digits are displayed on the screen:
Low freq: The frequency of the lower frequency component of the currently selected captured DTMF
digit.
High freq: The frequency of the higher frequency component of the currently selected captured DTMF
digit.
To Next Page
Loading...