Electrolux W3 SERIES - Scale Adjustments and Calibration

43
Procedure for use
Scale adjustments
4777
Press b repeatedly
until SCALE ADJUST-
MENTS is highlighted.
Press SELECT.
Scale adjustments
The following functions are accessed via the
SCALE ADJUSTMENTS menu:
Reset scale to zero (see section ”Reset scale to
zero”)
Used to make the weighing equipment display 0
when the machine has no load in it.
Reset tare to zero (see section ”Reset tare to
zero”)
Used to clear a stored tare parameter.
Tare scale (see section ”Tare scale”)
Used to reset the weighing equipment so that a
weight such as a container will not be included
when calculating net weight.
Set tare to a certain value (see section ”Set tare
to a certain value”)
Used to enter a value for the tare parameter, a
weight in hectograms.
Read tare value (see section ”Read tare value”)
Used to check the value currently stored as the
tare parameter.
Calibrate the scale (see section ”Calibrate the
scale”)
This function is used only on installation of a new
scale unit.
Zero calibration (see section ”Zero calibration”)
Used to increase the accuracy of the weighing
equipment.
Read version number (see section ”Read version
number”)
This is where you find the version number of the
weighing equipment.
If the weighing equipment is not connected, the
error message “WEIGHING EQUIPMENT NOT
CONNECTED” will be displayed. Connect the
weighing equipment and try again. If necessary,
see the section “Fault-finding, weighing equip-
ment” in the machine manual.
For machines with weighing equipment installed only!
Press SELECT.
When you have finished:
Press b repeatedly
until EXIT is highlighted.
SERVICEPROGRAM
MAKE A CHOICE:WATER
SERVICEPROGRAM
CLEAR COUNTER
CLEARSERVICECOUNTER
CLEAR WASH COUNTER IN CLS
CLEAR WASH COUNTER IN MEMORY CARD
SCALE ADJUSTMENTS
SELECT
SELECT
SERVICEPROGRAM
CLEAR COUNTER
CLEARSERVICECOUNTER
CLEAR WASH COUNTER IN CLS
CLEAR WASH COUNTER IN MEMORY CARD
SCALE ADJUSTMENTS
EXIT
SELECT