Electrolux W3 SERIES - Page 44

44
Procedure for use
Reset scale to zero
Check that ”RESET
SCALE TO ZERO” is high-
lighted.
If it isn’t...
Press c or b as
required to highlight ”RE-
SET SCALE TO ZERO”.
Press SELECT.
Reset scale to zero
”Reset weighing equipment” is used to make the
weighing equipment display 0 when the machine
has no load in it.
If your attempt to reset the weighing equipment
fails at this point, you will see an error message
equivalent to: “FAILED. PRESS SELECT” on
the display. For troubleshooting, see the sec-
tion “Fault-finding, weighing equipment” in the
machine manual.
This screen shows that the
weighing equipment has
been reset to zero.
Press SELECT.
For machines with weighing equipment installed only!
Please note:
The machine must be unladen when you use this
function, i.e. no water or wash load in the drum.
Please note:
After a power-cut, the weighing equipment will
always display 0, no matter what the actual load
in the drum. In this event you will have to use the
“Reset scale to zero” function.
3583
SERVICEPROGRAM
MAKE A CHOICE:
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SETTARETOACERTAINVALUE
READTAREVALUE
CALIBRATE THE SCALE
SELECT
RESET SCALE TO ZERO
RESET TARE TO ZERO
TARE SCALE
SETTARETOACERTAINVALUE
READTAREVALUE
CALIBRATE THE SCALE
ZERO CALIBRATION
READVERSIONNUMBER
EXIT
SELECT
SCALE ADJUSTMENTS
RESET SCALE TO ZERO
DONE! PRESS SELECT
SELECT
SELECT
3588