Procedure for use
No water reduction
During program operation
the display will look like
this (see section ”To start
the wash program”).
Press
c or bone or
more times to highlight
”NO WATER REDUC
-
TION”.
Press SELECT.
4776
No water reduction
The wash load is weighed during the program and the
water level is adjusted automatically according to its
weight. If the load is not a full one, the water level will
be reduced according to a water level reduction table.
You can switch off water level reduction at any stage of
a program.
Note that if you select ”NO WATER REDUCTION”, this
applies only to the program currently running. The next
time a program is started, water level reduction will oc-
cur automatically again.
For machines with weighing equipment installed only!
To Next Page
Loading...
