Transition Layer: The number of transition layers after the bottom layers for a tighter bonding
between layers. Except for the exposure time, other parameters of the transition layer are the
same as the normal layer.
Transition Type: Set the transition type of exposure time when transitioning from bottom layers
to normal layers, the default is linear transition.
Wait After Cure: The time difference between the end of the exposure and the start of the build
platform to leave the printing surface, the default setting is 0 seconds.
Wait After Lift: After the printing platform is lifted, the time difference between the printing
platform starts to stationary and starts to return, the default setting is 1 seconds.
Wait Before Cure: After the build platform moves to the printing surface, the time difference
between the build platform starting to stationary and starting to exposure, the default setting
is 1 seconds.
Bottom Lift Distance: During the bottom printing process, the distance that the build platform
leaves the printing surface each time, the default setting is 3+4mm.
Lifting Distance: In the normal layer printing process, the distance that the build platform leaves
the printing surface each time, the default setting is 3+4mm.
Bottom Retract Distance: During the bottom printing process, the retract distance of the build
platform, please do not change if not necessary.
Retract Distance: In the normal layer printing process, the retract distance of the build platform,
please do not change if not necessary.
Bottom Lift Speed: During the bottom printing process, the moving speed of the build platform
away from the printing surface each time, the default setting is 85+300mm/min.
Lifting Speed: In the normal layer printing process, the moving speed of the build platform away
from the printing surface each time; the default setting is 85+300mm/min.
Bottom Retract Speed: During the bottom printing process, the moving speed of the build platform
is close to the printing surface; the default setting is 300+70mm/min.
Retract Speed: In the normal layer printing, the moving speed of the build platform is close to the
printing surface; the default setting is 300+70mm/min.
Software Installation and Setup
To Next Page
Loading...
