Elesa DD52R-E - 7 Operating Mode; Absolute; Incremental Measuring Mode Selection; Measure Unit Selection

11
DE
DD52R-E (GN 9053) - DD52R-E-RF (GN 9153)
Modelle, alle Rechte vorbehalten in Übereinstimmung mit dem Gesetz.
Bei Reproduktion der Zeichnungen, bitte immer Quellenangabe.
7 Operating mode
7.1 Absolute / incremental measuring mode selection
Press the key to select the absolute or incremental measuring mode.
The measuring mode selected is shown on the display by the symbols:
- ABS : absolute measuring mode
- REL : incremental measuring mode
It is possible to change the key function by chosing one of
the available options in the voice menu __0___
The available options are:
- ArCLr (default): passing from ABS to REL the counter is set to zero.
- Ar : passing from ABS to REL the counter is not set to zero. In this case, the
counter is set to zero by pressing
+
.
- OFF : the key is disabled and does not allow changing the selected
measuring mode.
To program the parameters listed above, see cap. 8.
7.2 Measure unit selection
Press the key to select the unit of measure needed. The options available are
millimeters, inches and degrees.
The measuring mode selected is shown on the display by the symbols:
- mm : millimeters - INCH : inches - D : degrees
It is possible to change the key function by chosing one of
the available options in the voice menu 0_____
The available options are:
- ALL (default): units of measure that can be selected: mm, inch, degree
- nodEG : units of measure that can be selected: mm, inch
- OFF : the key is disabled and does not allow changing the selected measuring mode.
To program the parameters listed above, see cap. 8.
__0___
0_____