5 Installation and Commissioning
44
5.1.3 ELCORplus Indexer corrector
Fig. 3 ELCORplus Indexer device dimensions
5.2 Security Marks of the Device
Security marks on the device indicate the technical condition of the device from the point of view
of unauthorized manipulation.
Security Mark MID (Metrological Seal, not applicable to the logger)
- Its form is prescribed by the certificate for Quality Management System for Production, Output
Control and Testing according to Annex No 2, Procedure D, NV 120/2016 Coll., issued by Notified
Body No 1383. This security mark together with the CE conformity marking and the
supplementary metrology marking, e.g. M19 , have of the same significance for the user in the
Czech Republic as the Official Mark of initial verification according to the Metrology Act (§9 Par.
3).
According to Decree 345/2002 Coll. there is a validation period of 5 years in the Czech Republic
(valid on the assumption that the gas volume correctors are subject to a regular short verification
test with a validity of 1 year).
When this mark is breached, the manufacturer cannot guarantee that the device features are in
compliance with the EU type-examination certificate.
Manufacturer’s Seal
- Inspection mark of the manufacturer according to the manufacturer’s needs.
To Next Page