FC BASIC User Manual
23/24
8 USE OF THE DEVICE
8.1 Permitted use
To ensure safety, FC Basic must be installed and operated in accordance with the instructions supplied, and access to high
voltage components must be prevented under regular operating conditions. The device shall be properly protected against
water and dust and shall be accessible by using a tool only.
Any use other than the permitted use is forbidden.
9 RESPONSIBILITY AND RESIDUAL RISKS
Eliwell shall not be held liable for any damage incurred as a result of:
installation/use other than those intended, and, in particular, failure to comply with the safety instructions specified by
applicable regulations and/or provided in this document;
use with equipment which does not provide adequate protection against electric shocks, water and dust under the
effective conditions of installation;
use with equipment which permits access to hazardous parts without the use of tools;
installation/use with equipment which does not comply with current regulations and legislation.
10 DISCLAIMER
This document is exclusive property of Eliwell Controls srl. and cannot be reproduced and circulated unless expressly
authorized by Eliwell Controls srl
Although all possible measures have been taken by Eliwell Controls srl l. to guarantee the accuracy of this document, it
does not accept any responsibility arising out of its use.
To Next Page
Loading...
Need help?
General
