Eliwell RGF 312 - Page 6

RGF 300
6/53
Like all our products, the
rgf300
series bears
CE
marking as required by directive
89/336/ECC
and its
subsequent modification
EEC/92/31
on electromagnetic compatibility.
Since all these products are not used as "
stand alone
" appliances but incorporated into other plants or
machines, the standards' compatibility test was carried out under typical operating conditions.
The essential requirements of the directive are satisfied by conformity to "
generic standards
" for heavy
industry.
EN 50081-2
emission standard,
EN 50082-2
immunity standard, and in particular:
EN 55011
class B, for radiated disturbances
EN 55011
class A, for conducted disturbances
ENV 50140 (IEC 801-3)
for susceptibility (on the power supply)
ENV 50141
for conducted susceptibility on power lines
IEC 801-4
for fast transistors (bursts / high frequency disturbances)
IEC 801-2
for electrostatic discharge (
ESD
)
The tests and checks for conformity have been carried out according to the procedures described in the
product's technical documentation. The system used was formed by an
rgf300
voltage regulator, a control
cable and relative controls, a power supply cable, a motor cable and a fan.
fig. 2
Responsibility for the final characteristics of the system or plant regarding the EMC directive
rests with the installer. The equipment must be installed in observance of the regulations in
force using the information presented in this manual.
3
IP 55
120°C
STOCK & WORK
- 20
+85
°C
UR%
- 20
+50
°C