31
4-Step Memory Buttonholes – Classic and
Bound
019 Classic Buttonhole (4 Step Memory)
This buttonhole is especially suited for oversized novelty
buttons or larger decorative openings. All buttonholes
should use interfacing suitable for the fabric weight. Test
sew buttonhole on sample swatch.
Select 019. The LCD screen will briefly show two
messages.
Use either the R or B buttonhole foot. If you use the R
foot, fully extend open the buttonholder q (maximum
buttonhole size with this foot is 3.2 cm or 1 1/4˝).
DO NOT pull down the buttonhole lever.
Alter the buttonhole width to match the fabric and thread.
Mark the buttonhole area on the fabric. Place both
threads to the left under the foot. Insert the garment
under the foot and hand turn the flywheel to lower the
needle at the starting point. Lower the buttonhole foot.
Start sewing - zigzag backwards on left side. Stop
sewing when you reach the desired buttonhole length.
Press “Reverse” key.
Start sewing - back bartack and zigzag forward on right
side. Stop sewing when you are opposite the starting
point.
Press “Reverse” key.
q
To Next Page
Loading...
