ELNA eXperience 660 - Individually Adjusting Stitch Width or Length; Alignment of Stitches Within a Sequence

Individually Adjusting Stitch Width or Length
If the cursor is positioned under a stitch in the
programmed sequence, the stitch width or length
adjustment is applied only to that stitch.
q Program 046 two times.
w Press “Review Memory Left” key to move cursor.
e Press “–” on “Stitch Width/Needle Position” key.
r Press “–” on “Stitch Length” key.
t Place fabric and stabilizer under foot and sew.
Alignment of Stitches Within a Sequence
Often stitches in a sequence have different needle start
positions – left, center or right. Your machine will
automatically determine a common alignment point
based on the stitches in the sequence. There are 4
possibilities:
q Left and center needle positions are aligned to left.
w Right and center needle positions are aligned to right.
e Left and right needle positions are aligned to center.
r Left, center and right needle positions are aligned to
center.
38
q
w
e
r
t
q
w
e
r