105U-G Wireless Gateway User Manual
Page 41 © August 2003
Change Sensitivities
Radio messages to remote modules can be change messages (when the value of the I/O
register changes) or update messages (when the update time has elapsed). If a change
message is sent, the update period restarts.
You can configure the amount of change required to trigger a change message - this is called
the change sensitivity. Sensitivities are configured for blocks of I/O registers - that is, each
I/O register does not have a unique sensitivity. You can configure up to 50 sensitivity values
- that is, there can be 50 blocks of registers with different sensitivities.
For more information on this, refer to section 4.5.
To Next Page
Loading...
