ELTEX ESR-100 - 7.35 BRAS (Broadband Remote Access Server) configuration

ESR Series Routers Operation Manual 101
Define receiver-server of Trap-PDU messages
esr(config)# snmp-server host 192.168.52.41
Configuration changes will take effect when the configuration is applied:
esr# commit
Configuration has been successfully committed
esr# confirm
Configuration has been successfully confirmed
7.35 BRAS (Broadband Remote Access Server) configuration
Objective: Provide access to the Internet only to authorized users.
Fig. 7.3 – Network structure
Solution:
SoftWLC server keeps accounts data and tariff plan parameters. You can obtain more detailed
information on installation and configuring SoftWLC server using following links:
http://kcs.eltex.nsk.ru/articles/960 - general article of SoftWLC;
http://kcs.eltex.nsk.ru/articles/474 - SoftWLC installation from repositories.
The BRAS license is obligatory for router, after its activation you can start device configuring.
Create 3 security zones, according to the network structure depicted in
Fig. 7.3:
esr# configure
esr(config)# security zone trusted
esr(config-zone)# exit
esr(config)# security zone untrusted
esr(config-zone)# exit
esr(config)# security zone dmz
esr(config-zone)# exit
Configure public port parameters and assign its default gateway:
esr(config)# interface gigabitethernet 1/0/1
esr(config-if-gi)# security-zone untrusted
esr(config-if-gi)# ip address 203.0.113.2/30