ELTEX MES1000 User Manual

54 MES1000, MES2000 Ethernet Switches
destination-url:
(1..160) characters
destination address in SNMP format
- source_url—source location of the file being copied
- destination_url—destination location for the file to be copied
to
copy source_url image
Copy the system firmware file from the server into non-volatile
memory.
copy source_url boot
Copy the load file from the server into non-volatile memory.
copy source_url
running-config
Copy configuration file from the server into the current
configuration.
copy source_url
startup-config
Copy configuration file from the server into the initial
configuration.
copy running-config
destination_url
Save the current configuration on the server.
copy startup-config
destination_url
Save the initial configuration on the server.
copy running-config
startup-config
-
Save the current configuration into the initial configuration.
copy running-config file
-
Save the current configuration into the specified backup
configuration file.
copy startup-config file
-
Save the initial configuration into the specified backup
configuration file.
copy running-config
backup-config
-
Save the current configuration into the backup configuration
file.
copy startup-config
backup-config
-
Save the initial configuration into the backup configuration file.
dir
-
Display the list of files in the flash memory
more {flash://<file> |
startup-config |
running-config |
mirror-config | <file>}
<file> - (1..160) characters
Show file contents.
- startup-config—show the contents of the initial configuration
file
- running-config—show the contents of the current
configuration file
- flash:// - show files from USB flash drives
- mirror-config—show the current configuration file contents
from the mirror
- file—filename
File contents are shown in ASCII standard, except for
image files that are shown in hexadecimal format.
*.prv files are not shown.
delete url
-
Delete the file from the device flash memory.
*.prv, image-1 and image-2 files cannot be removed.
delete startup-config
-
Delete the initial configuration file.
boot system
[unit unit] {image-1|
image-2}
unit: (1..4)
Define the system firmware file, that will be loaded on startup.
- unit—number of the device in a stack (for standalone switch,
this parameter is not used)
show running-config
-
Show contents of the current configuration file.
show startup-config
-
Show contents of the initial configuration file.
show bootvar [unit unit]
unit: (1..4)
Show the active system firmware file, that device loads on
startup.
- unit—number of the device in a stack (for standalone switch,
this parameter is not used).
During command execution, [unit unit] parameter is
available in the stackable mode only.
write [memory|terminal]
Save the current configuration into the initial configuration file.
rename url new_url
url: (1 .. 160)
Change the filename.
- url—current filename
- new_url—new filename

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English