ELTEX MES1000 User Manual

100 MES1000, MES2000 Ethernet Switches
flex-link preemption delay
delay
delay: (1..300)/35
When disabled port status changes to 'up', specifies the
amount of time that should pass for an action, set by flex-link
preemption mode command, to be executed.
no flex-link preemption
delay
Restore the default value.
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.91 —EXEC mode commands
Command
Value
Action
show interfaces flex-link
[detailed] { gigabitethernet
gi_port | fastethernet
fa_port | port-channel
port-channel}
gi_port: (1..4/0/1..28);
fa_port: (1..4/0/1..24);
port_сhannel: (1..8)
Displays flex-link function configuration.
5.16.7 EAPS protocol
EAPS (Ethernet Automatic Protection Switching) protocol allows to increase stability and robustness
of data network with ring topology by decreasing the restoration time after the failure. Restoration time
does not exceed 1 second, that is substantially lower than the network reconstruction in case of spanning
tree family protocols.
Global configuration mode commands
Command line request in global configuration mode appears as follows:
console(config)#
Table 5.92 —Global configuration mode commands
Command
Value/Default value
Action
eaps
-
Enable EAPS protocol operation.
no eaps
Disable EAPS protocol operation.
eaps fail-timer seconds
(1..10)/3 seconds
Define the absence time for test packets, that should pass for
ring failure to be registered.
no eaps fail-timer
Set the timer default value.
eaps hello-timer seconds
(1..10)/1 seconds
Hello-packet sending frequency timer.
no eaps hello-timer
Set the timer default value.
eaps domain domain_id
0..63
Create EAPS region with domain-id identifier and enter the
region configuration mode.
no eaps domain domain_id
Remove EAPS region with domain-id identifier.
Domain configuration mode commands
Command line request in domain configuration mode appears as follows:
console(config-eaps-domain)#
Table 5.93 —EAPS domain configuration mode commands
Command
Value/Default value
Action
control-vlan vlan_id
1..4093
Identifier of VLAN being used for EAPS management. Also, the
next successive VLAN identifier is used for secondary loop
management. Master EAPS VLAN should not be used for
transmission of other traffic types.
no control-vlan
Cancel VLAN assignment.

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English