ELTEX MES1000 User Manual

MES1000, MES2000 Ethernet Switches 91
console(config)# interface {gigabitethernet gi_port| fastethernet fa_port
|port-channel group}
console(config-if)#
Table 5.73 —Ethernet interface configuration mode commands, interface group
Command
Value/Default value
Action
gvrp enable
-/disabled
Enable GVRP utilization for configured interface.
no gvrp enable
Disable GVRP utilization for configured interface.
garp timer
{join | leave | leaveall}
timer_value
timer_value:
(10-2147483640) ms
Default values:
join: 200 ms
leave: 600 ms
leaveall: 10000 ms
Set the GARP timer value (for time description, see Table
5.74).
timer_value—timer value (must be divisible by 10).
no garp timer
Set default values.
gvrp vlan-creation-forbid
-/enabled
Disable dynamic VLAN modification or creation for configured
interface.
no gvrp vlan-creation-
forbid
Enable dynamic VLAN modification or creation for configured
interface.
gvrp registration-forbid
Be default, VLAN creation
and registration is enabled
for the interface.
Deregister all VLANs and disable the creation or registration of
new VLANs on the current interface.
no gvrp registration-forbid
Restore the default value.
Table 5.74 —GARP timer description
GARP timer
Value
Join Timer
Define the request transmission interval for adding VLAN into the group (value
range from 10 to 2147483640 ms, default value 200 ms).
Leave Timer
Define the amount of time the interface will wait before leaving the VLAN group
(value range from 10 to 2147483640 ms, default value 600 ms).
Leave timer value should be greater or equal to 3 x Join timer value.
LeaveAll Timer
Define the amount of time the interface will wait before sending LeaveAll request
for complete disconnection from VLAN group (value range from 10 to 2147483640
ms, default value 10000 ms).
Leave timer value should be much greater than Leave timer value.
GARP timer values should be the same for all communicating devices. If timer values are
different, the switch will not be able to operate with GVRP protocol correctly.
Communication of untagged and tagged ports can be defined administratively by setting
PVID value for the untagged port.
Interface configured in the access port mode will not be able to work with GVRP protocol,
since it always belongs to only one VLAN group.
Privileged EXEC mode commands
Command line request in privileged EXEC mode appears as follows:
console#
Table 5.75 —Privileged EXEC mode commands
Command
Value
Action
clear gvrp statistics
gi_port: (1..3/0/1..28);
Clear collected GVRP statistics.

ELTEX MES1000 Specifications

General

Brand	ELTEX
Model	MES1000
Category	Switch
Language	English