____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 25
– Status—the status of voice daemon
– Number—phone number
4.2 Advanced Setup menu. Advanced configuration
4.2.1 LAN submenu. Configuration of Main Parameters
The menu allows you to configure main parameters of the LAN interface.
– IP Address—device address in local network
DHCP Server
DHCP server (Dynamic Host Configuration Protocol) enables automatic configuration of local PC to work in
network. DHCP server automatically assignes IP addresses to each computer within a network.
– Enable — when checked, enable DHCP server (dynamically assign IP addresses from the following range)
– Start IP Address — starting address of the range
– End IP Address — ending address of the range
– Leased Time (hour) — address lease time (in hours).
Static IP Lease List
The DHCP Static IP Lease tab is used to establish correspondence between leased IP addresses and
devices' МАС addresses (mapping). To add a record into a table, click Add. You can establish up to 32 matches.
To Next Page
Loading...
Need help?
General
