ELTEX NTU-RG-1421G-WZ - The Z-Wave Menu; The Upnp Submenu. Autoconfiguration of Network Devices

____________________________________________________________________________________
____________________________________________________________________________________
38 NTU Optical Network Terminals
4.2.8 The “Z-Wave” menu
Use this menu to configure “Smart Home” parameters.
– Enable Zway—enable/disable “Smart Home” controller;
– Host name—specify IP address of “Smart Home” remote platform;
– Port—specify the platform port to which “Smart Home” controller is connected;
– Enable secure connection—set the flag if secure channel is used to share data with the platform;
– Reset Zway cache—when clicking the button, the controller is turned off; all information about the
connection to the platform, linked sensors and scripts is deleted from it.
Click the Apply/Save to accept and save the settings.
4.2.9 The “UPnP” submenu. Autoconfiguration of network devices
Use the menu to configure Universal Plug and Play (UPnP™) function.
UPnP ensures compatibility with network equipment, software and peripheral devices.
Configure NAT on an active WAN interface, to use UPnP.
Set the Enable UPnP flag to enable UPnP.
Click Apply/Save button to accept and save the settings.