____________________________________________________________________________________
____________________________________________________________________________________
NTU Optical Network Terminals 39
4.3 The “Wireless” menu. Wireless network configuration
This section contains individual settings for each of the operating bands—2.4GHz and 5GHz.
4.3.1 The “Basic” submenu. General settings
This menu is intended for general setup of the LAN wireless interface and allows user to specify up to
three wireless access points.
– Enable Wireless — enables Wi-Fi on the device.
– Enable Access Point—enable Hotspot2.0 support on the device;
– Hide Access Point—access point hidden operation mode (in this mode, wireless network SSID won't be
broadcast by the router);
– Clients Isolation—when checked, wireless clients will not be able to interact with each other;
– Disable WMM Advertise—disable WMM (Wi-Fi Multimedia—a QoS for wireless networks);
– Enable Wireless Multicast Forwarding (WMF)—enable WMF;
– SSID (Service Set Identifier)—assign a wireless network name (case sensitive).
Default device SSID is ELTX-2.4GHz_WiFi__aaaa/ELTX-5GHz_WiFi_aaaa, where аааа—the last 4 digits
of WAN MAC. WAN MAC is labelled on the device housing. The network name contains a frequency
band (2.4/5GHz).
To Next Page
Loading...
