ELTEX NTU-RG-5402G-W - The Routing Submenu. Routing Configuration

 NTU-RG-54xx. User manual (user)
45
•
•
•
•
•
•
4.5.3 The 'Routing' submenu. Routing configuration
This submenu is used to configure static routing.
Advance → Routing
To add the static route check 'Enable', fill the corresponding fields and click 'Add Route'.
Enable –flag for route adding;
Destination– destination address;
Subnet Mask–subnet mask;
Next Hop–next host;
Metric–metric;
Interface– interface.
Added static routes are displayed in the 'Static Route Table'. To update the information in the table, click the
'Update' button, to delete the position from the table select it and click 'Delete Selected''.
To view the routes that the device often accesses, click the 'Show Routes' button, then the 'IP Route Table' will
be displayed.
Advance → Routing→ Show Routes
To update the information in the table, click the 'Refresh' button, to close the table, click 'Close'.