ELTEX NTU-RG-5402G-W - The Remote Access Submenu. Remote Access Rules Configuration

 NTU-RG-54xx. User manual (user)
55
•
•
•
•
•
•
4.7.7 The 'Remote Access' submenu. Remote access rules configuration
In this section you can configure remote access rules via HTTP/Telnet/ICMP protocols.
Admin → Remote Access
Enable – enabling the rule to add;
Service – selection of the protocol used;
Interface – interface to which the rule applies;
IP Address – source IP adress;
Subnet Mask – subnet mask;
Port – destination port.
To add a rule fill the corresponding fields and click the 'Add' button. Added rules are displayed in the 'RA Table'.
To activate/deactivate the selected rule, click the 'Toggle selected' button. To delete one rule, select it with a
flag in the Select column and click the 'Delete Selected' button.