ELTEX TAU-8.IP - Page 23

____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways 23
– Autoupdate (Provisioning mode)– type selection of autoupdate:
– Disabled – autoupdate is disabled;
– Configuration & firmware – performed autoupdate of configuration and firmware;
– Configuration only – provides only autoupdate of configuration;
– Firmware only – provides only firmware autoupdate.
– Priority from – priority selection of file determination for autoprovigioning:
– DHCP options – when this priority is selected, URL of configuration file and firmware are
determined by using 43, 66 and 67 DHCP-options for that purpose one of the services should
have address getting configured via DHCP.1
If you couldn’t eject autoupdate parameters the following URL parameters will be used
by default:
tftp://update.local/<MAC>.cfg – URL of the configuration file (where <MAC> is MAC-
address of the device, and symbol ‘.’ is byte-separator) tftp://update.local/tau8.fw is
URL of firmware file.
– Configuration update interval, sec – determinates configuration update interval. 0 value
means that update will be applied only once when the device is launched;
– Firmware update interval, sec – determinates firmware update interval. 0 value means
update will be applied only once when the device is launched.
– Static settings – when this priority is selected, you should specify file location to update
configuration and firmware;
If the path to a file is absent, the following values will be used by default:
tftp://update.local/tau8.cfg – URL of configuration file;
tftp://update.local/tau8.fw- URL of firmware file.
– Configuration file – full configuration pathname in the URL format (TFTP-, HTTP-, HTTPS-
and FTP-URLs are supported, for example, tftp://update-server.loc/tau8.conf);
– Firmware update interval, sec – determines configuration update interval. 0 value means
update will be applied only once during the device start;
– Firmware file – pathname of firmware in the URL format (TFTP-, HTTP-, HTTPS- and FTP-
URLs are supported, for example, tftp://update-server.loc/tau8.conf);
– Configuration update interval, sec – determines firmware update interval. 0 value means
update will be applied only once during the device start.
See a detailed description of DHCP-based autoprovisioning operation algorithm in the chapter 6
Autoprovisioning procedure operation algorithm via DHCP .
TR-069 Configuration:
– Enable TR-069 client – when checked, integrated TR-069 protocol client will be enabled;
– ACS URL – autoconfiguration server address. Enter address in the following format:
http://x.x.x.x:10301 (х.х.х.х – ACS server IP-address or domain name, 10301 – ACS server port by
default);