ELTEX TAU-8.IP - FXS Profiles

____________________________________________________________________________________
____________________________________________________________________________________
VoIP subscriber gateways 63
Call forward on busy number (CFB number) – number that incoming calls will be
forwarded to when the subscriber is busy and Call forward on busy service is enabled (in
SIP profile being used, a prefix for this direction should be defined in the numbering
schedule.);
– Call forward on no answer (CFNA) – when active, all incoming calls will be forwarded to the
specified number, if there is no answer from the subscriber. When flag is set, fill in the following
fields:
Call forward on no answer (CFNA number) – number that incoming calls will be forwarded
to when there is no answer from the subscriber and Call forward on no answer service is
enabled (in SIP profile being used, a prefix for this direction should be defined in the
numbering schedule.);
CFNA timeout, sec – time interval that will be used for call forwarding when there is no
answer from the subscriber, in seconds;
– Do not disturb (DND) – when checked, temporary restriction is placed for incoming calls (DND
service – Don’t Disturb);
– CLIR – caller ID service restriction:
– Off – CLIR service is disabled;
– SIP:From – ‘anonymous’ will be sent in the ‘From’ header of ‘SIP’ message;
– SIP:From and SIP:Contact – «anonymous» will be sent in the ‘From’ and ‘Contact’ headers
of SIP messages.
When multiple services are enabled simultaneously, the priority will be as follows (in the descending
order):
– CFU;
– DND;
– CFB, CFNA.
3.1.4.3.2 FXS profiles
Click ‘FXS status’ button for fast transition to the ‘Status/Telephony’ submenu (section 4.2.8), where
monitoring statistic of subscriber line unit, call group and serial group is available.
Delete profile is not recommended, if it is used by only one port.
Click button in ‘Action' column of ‘FXS profiles’ table to edit profile. To delete it, click button. To
add new profile, click ‘Add new profile’ button. The list of FXS profile settings is shown below.